Club Car Carryall 500 2015 Maintenance And Service Manual page 337

ELECTRICAL COMPONENTS: PEDAL-START
GAS VEHICLE
492
BEARING CLEANING AND INSPECTION
1. Using a clean cloth, wipe the carbon dust from the two bearings. Inspect bearings by spinning them by hand and
checking for both axial (A) and radial (B) play (Figure 20-7, Page 20-5).
2. Replace the bearing if it is noisy, does not spin smoothly, or has excessive play. Check the bearings and replace if
rusted, worn, cracked, or if there is an abnormal color change in the metal of the bearing. Bearings should be
replaced if there is extensive wear or pitting on the balls or on the rolling surfaces. Do not remove the bearings
unless they are to be replaced.
A
493
Figure 20-7 Bearing Play Inspection
Figure 20-6 Armature and Output End Cover Assembly
B
2015 Carryall 500 and 700 Maintenance and Service Manual
20
Starter/Generator
39
Page 20-5