Table of Contents
Advertisement
ELECTRICAL COMPONENTS: PEDAL-START
GAS VEHICLE
MAINTENANCE/OPERATE SWITCH
TESTING THE MAINTENANCE/OPERATE SWITCH
See Test Procedure 9 – Maintenance/Operate Switch – Pedal-Start Vehicles on page 18-30.
MAINTENANCE/OPERATE SWITCH REMOVAL
1.
Disconnect the battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles on page
1-4.
2.
Using a 5/8 inch (16 mm) wrench, remove maintenance/operate boot/hex nut.
3.
Remove maintenance/operate switch from bracket.
4.
Disconnect the two spade terminals and remove switch.
MAINTENANCE/OPERATE SWITCH INSTALLATION
1.
Connect the three spade terminals (Figure 18-14, Page 18-30).
2.
Make sure groove switch is aligned with tang on bracket and install switch. Tighten maintenance/operate switch
boot/hex nut to 16 in·lb (1.8 N·m).
3.
Connect the battery. See Connecting the Battery – Gasoline Vehicles on page 1-4.
NEUTRAL LOCKOUT LIMIT SWITCH
See General Warnings on page 1-1.
TESTING THE NEUTRAL LOCKOUT LIMIT SWITCH
See Test Procedure 10 – Neutral Lockout Limit Switch – Pedal-Start Vehicles Only on page 18-31.
NEUTRAL LOCKOUT LIMIT SWITCH REMOVAL
1.
Turn the key switch OFF and remove the key. Place the Forward/Reverse handle in the NEUTRAL position.
Chock the wheels.
2.
Disconnect battery and spark plug wire(s). See Disconnecting the Battery – Gasoline Vehicles, Section
1, Page 1-4.
3.
Disconnect the 3-wire connector from the neutral lockout limit switch (1) located on the transaxle.
4.
Remove two nuts (3) and washers (4) from the neutral lockout limit switch (1) and slide the limit switch off of
the screws.
NEUTRAL LOCKOUT LIMIT SWITCH INSTALLATION
1.
Install the limit switch (1) with washers (4) and nuts (3) and tighten to 5 in·lb (0.6 N·m). Move the Forward/Reverse
handle to make sure the switch actuates. See following CAUTION.
2015 Carryall 500 and 700 Maintenance and Service Manual
Maintenance/Operate Switch
20
Page 20-17
Advertisement
Table of Contents
Troubleshooting
