Table of Contents
Advertisement
21
Key Switch
3.
Disconnect the wires from the key switch. Do not allow wires to touch.
4.
From the back of the instrument panel, push down on the retaining tabs surrounding the key switch (3) and
remove the key switch cap (6). Using a 1-inch socket, hold the key switch (3) and remove the switch retaining nut
(5) from the outside of the instrument panel (Figure 21-1, Page 21-2).
KEY SWITCH INSTALLATION
1.
Position the key switch (3) and key switch washer (1) in the instrument panel, then install and tighten the key
switch nut (5) to 35 to 45 in·lb (4 to 5 N·m). Install key switch cap (6) into instrument panel, align the bent washer
tab with the slot in the plastic.(Figure 21-1, Page 21-2).
2.
Refer to the wiring diagram to connect the wires to the key switch terminals. See Wiring Diagrams, Section 19,
Page 19-2.
3.
Install instrument panel. See Instrument Panel Installation on page 4-9.
4.
Connect the battery and spark plug. See Connecting the Battery – Gasoline Vehicles, Section 1, Page 1-4.
2931
Figure 21-1 Key Switch
Page 21-2
2015 Carryall 500 and 700 Maintenance and Service Manual
1
3
2
4
ELECTRICAL COMPONENTS: KEY-START
GAS VEHICLE
Advertisement
Table of Contents
Troubleshooting
