Club Car Carryall 500 2015 Maintenance And Service Manual page 336

20
Starter/Generator
Figure 20-5 Pull Brushes Away From Center of the Commutator End Cover
DISASSEMBLY OF THE STARTER/GENERATOR TO SERVICE THE
ARMATURE/COMMUTATOR
1. If the brushes are not removed, contact between the brushes and commutator as the commutator end cover is
being removed or installed could damage the brushes.
1.1. Lift the brush springs and pull the brushes back from the center of the commutator end cover. The springs
will rest on the sides of the brushes and help prevent them from sliding towards the center of the cover
(Figure 20-5, Page 20-4).
2. Remove the two bolts (20), and pull commutator end cover (23) free of the starter/generator housing (24) (Figure
20-1, Page 20-2).
3. To separate armature (33) from output end cover (36), remove nut (41), lock washer (40), pulley (39), shaft key
(34), spacer (37), and bearing retainer screws (43) (Figure 20-6, Page 20-5).
Page 20-4 2015 Carryall 500 and 700 Maintenance and Service Manual
ELECTRICAL COMPONENTS: PEDAL-START
GAS VEHICLE