Table of Contents
Advertisement
Figure 46. 24 x 2.5-inch drive backplane (top view)
1. BP_CTRL
3. BP_DST_PA1 (PCIe/NVMe connector)
5. BP_ DST_PB1 (PCIe/NVMe connector)
7. BP_ DST_PA2 (PCIe/NVMe connector)
9. BP_DST_SB1
11. BP_DST_SA1
Figure 47. 24 x 2.5-inch NVMe passive backplane
1. BP_DST_PB6 (PCIe/NVMe connector)
3. BP_DST_PB5 (PCIe/NVMe connector)
5. BP_DST_PA5 (PCIe/NVMe connector)
7. BP_DST_PA4 (PCIe/NVMe connector)
9. BP_DST_PA3 (PCIe/NVMe connector)
11. BP_PWR_1
13. BP_DST_PB1 (PCIe/NVMe connector)
Removing the drive backplane
Prerequisites
CAUTION:
To prevent damage to the drives and backplane, remove the drives from the system before removing
the backplane.
CAUTION:
Note the number of each drive and temporarily label them before you remove the drive so that you
can reinstall them in the same location.
2. BP_PWR_1 (backplane power and signal cable to system
board)
4. BP_PWR_2 (backplane power and signal cable to system
board)
6. BP_PWR_CTRL
8. BP_ DST_PB2 (PCIe/NVMe connector)
10. BP_SRC_SA2
2. BP_DST_PA6 (PCIe/NVMe connector)
4. BP_PWR_2
6. BP_DST_PB4 (PCIe/NVMe connector)
8. BP_DST_PB3 (PCIe/NVMe connector)
10. BP_DST_PB2 (PCIe/NVMe connector)
12. BP_DST_PA2 (PCIe/NVMe connector)
14. BP_DST_PA1 (PCIe/NVMe connector)
Installing and removing system components
87
Advertisement
Table of Contents
