Table of Contents
Advertisement
5. If applicable, disconnect the cables from the expansion card or system board/PEM board.
Steps
1. Loosen the captive screws on the riser and system.
2. Disconnect the riser cable from the system board/PEM board (depending on the type of riser used.
3. Press the blue release tab or blue button on the riser and holding the edges lift the expansion card riser from the riser
connector on the system board.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 89. Removing the expansion card riser 1
Installing and removing system components
133
Advertisement
Table of Contents
