Removing A Power Supply Unit Adapter; Installing A Power Supply Unit Adapter - Dell PowerEdge R860 Installation And Service Manual

Removing a power supply unit adapter

Remove the PSU adapter, when installing PSU with 86 mm wide form factor.
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
Steps
Using a Phillips #1 screwdriver, loosen the screw and remove the power supply unit adapter.
Figure 155. Removing a power supply unit adapter
Next steps
1. Replace the PSU adapter

Installing a power supply unit adapter

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in
3. If required, Remove the
NOTE: Remove the PSU adapter, when installing PSU with 86 mm wide form factor.
Steps
1. Align and insert the power supply unit adapter.
2. Using a phillips #1 screwdriver, tighten the screw.
182 Installing and removing system components
Safety instructions.
Before working inside your
or Install the PSU.
Safety instructions.
Before working inside your
PSU.
system.
system.