Table of Contents
Advertisement
Figure 171. Installing the BOSS-N1 module blank
To install the BOSS-N1 module:
1. To install the BOSS-N1 module , see
2. To install the M.2 NVMe SSD and BOSS-N1 card carrier, see
NOTE:
Install a BOSS-N1 card carrier blank
NOTE:
Refer to
cable routing
system board connectors.
NOTE:
The installation of the BOSS-N1 module to the Riser 1 and 4 x 2.5-inch rear drive module is similar.
NOTE:
Installing the BOSS-N1 card carrier does not require the system to be powered off. System shutdown is only
required when installing the BOSS-N1 controller card module.
200
Upgrade Kits
installing the BOSS-N1 module
if you are only using one BOSS-N1 card carrier.
section, configuration 49 and 50 for more information on connecting the BOSS cables to
steps 1 to 5.
installing the BOSS-N1 module
steps 6 to 10.
Advertisement
Table of Contents
