Dell PowerEdge R860 Installation And Service Manual page 99

Figure 59. Configuration 7: 24 x 2.5-inch (SAS4/SATA) + 2 x 2.5-inch (SAS/SATA) with fPERC 12
NOTE: Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 75. 24 x 2.5-inch (SAS4/SATA) + 2 x 2.5-inch (SAS/SATA) with fPERC 12
Order From
1 CTRL_SRC_SB1_PB1 (fPERC controller
connector)
2 SL4_CPU1_PA3 (signal connector on system
board)
3 SL4_CPU1_PA3 (signal connector on system
board)
4 SIG_PWR_2 (system board power connector)
5 SIG_PWR_1 (system board power connector)
6 SL5_CPU1_PB3 (signal connector on system
board)
7 CTRL_SRC_SA1_PA1 (fPERC controller
connector)
8 SIG_PWR_0/BATT2 (system board power
connector)
To
BP_DST_SB1 (backplane signal connector)
CTRL_DST_PA1 (fPERC controller connector)
BP_DST_SA1 and BP_DST_SB1 (backplane signal
connector)
BP_PWR_2 (backplane power connector)
BP _PWR_1 (backplane power connector)
CTRL_DST_PB1 (fPERC controller connector)
EXP/BP_DST_SA1 (backplane signal connector)
BP _PWR_1 (Rear backplane signal connector)
Installing and removing system components 99