Table of Contents
Advertisement
Figure 166. Removing the right control panel
Next steps
1.
Replace the right control
Installing the right control panel
Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If installed,
remove the air
4.
Remove the cooling fan cage
5. If installed,
remove
PEM.
6.
Remove the side wall
Steps
1. Align and slide the right control panel into the slot on the system.
a. Route the right control panel cable through the side wall of the system.
2. Connect the right control panel cable and VGA cable to the connectors on the system board.
3. Align and slide the right control panel cable cover in the slot on the system.
NOTE:
Route the cable properly to prevent the cable from being pinched or crimped.
4. Using the Phillips #1 screwdriver, tighten the screws that secure the right control panel and the cable cover to the system.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
194
Installing and removing system components
panel.
Safety
Before working inside your
shroud.
assembly.
bracket.
instructions.
system.
Advertisement
Table of Contents
