Table of Contents
Advertisement
NOTE:
If you assign a new system and/or setup password with the jumper on pins 4 and 6, the system disables the new
password(s) the next time it boots.
5. Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.
6. Power off the system.
7.
Remove the system
cover.
8. Move the jumper on the system board from pins 4 and 6 to pins 2 and 4.
9.
Replace the system
cover.
10. Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.
11. Assign a new system and/or setup password.
Jumpers and connectors
207
Advertisement
Table of Contents
