Dell PowerEdge R860 Installation And Service Manual page 58

Table 57. System Profile Settings details (continued)
Option
Monitor/Mwait
Workload Profile
CPU Interconnect Bus Link
Power Management
PCI ASPM L1 Link Power
Management
System Security
To view the System Security screen, power on the system, press F2, and click System Setup Main Menu > System BIOS >
System Security.
Table 58. System Security details
Option
CPU AES-NI
System Password
Setup Password
Password Status
Table 59. TPM 2.0 security information
Option Description
TPM Information
TPM
NOTE:
Security
Enables you to control the reporting mode of the TPM. When set to Off, the presence of the TPM is not
reported to the OS. When set to On, the presence of the TPM is reported to the OS. The TPM Security option
is set to Off by default.
When TPM 2.0 is installed, the TPM Security option is set to On or Off. This option is set to Off by default.
TPM Indicates the type of Trusted Platform Module, if present.
Information
TPM Indicates the firmware version of the TPM.
Firmware
TPM
Enables, disables, or clears the storage and endorsement hierarchies. When set to Enabled, the storage and
Hierarchy
endorsement hierarchies can be used.
When set to Disabled, the storage and endorsement hierarchies cannot be used.
58 Pre-operating system management applications
Description
Enables the Monitor/Mwait instructions in the processor. This option is set to Enabled for all
system profiles, except Custom by default.
NOTE: This option can be disabled when System Profile is set to Custom.
NOTE: When C-States is set to Enabled in the Custom mode, changing the Monitor/
Mwait setting does not impact the system power or performance.
This option allows the user to specify the targeted workload of a server. It allows
optimization of performance based on the workload type. This option is set to Not
Configured by default.
Enables or disables the CPU Interconnect Bus Link Power Management. This option is set to
Enabled by default.
Enables or disables the PCI ASPM L1 Link Power Management. This option is set to
Enabled by default.
Description
Improves the speed of applications by performing encryption and decryption by using
the Advanced Encryption Standard Instruction Set (AES-NI). This option is set to
Enabled by default.
Sets the system password. This option is read-only if the password jumper is not
installed in the system.
Sets the setup password. This option is read-only if the password jumper is not installed
in the system.
Locks the system password. This option is set to Unlocked by default.
The TPM menu is available only when the TPM module is installed.