Table of Contents
Advertisement
c. Exit the System Setup.
d. To test the newly installed battery, check the time and date at least an hour after installing the battery.
e. Enter the System Setup and if the time and date are still incorrect, see
Optional internal USB card
NOTE:
To locate the internal USB port on the system board, see the
Removing the internal USB card
Prerequisites
CAUTION:
To avoid interference with other components in the server, the maximum permissible dimensions of
the USB memory key are 15.9 mm wide x 57.15 mm long x 7.9 mm high.
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3.
Remove the expansion card
Steps
1. Holding the blue tag, lift the internal USB card to disconnect from the connector on the system board.
2. Remove the USB memory key from the internal USB card.
Figure 145. Removing the internal USB card
Next steps
1.
Replace the internal USB
174
Installing and removing system components
Safety
instructions.
Before working inside your
risers.
card.
Getting help
System board jumpers and connectors
system.
section.
section.
Advertisement
Table of Contents
