Removing The Left Control Panel - Dell PowerEdge R860 Installation And Service Manual

Figure 167. Installing the right control panel
Next steps
1. Install the side wall bracket.
2. If removed, install PEM.
3. Install the cooling fan cage
4. If removed, install the air
5. Follow the procedure listed in

Removing the left control panel

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. If installed, remove the air
4. Remove the cooling fan cage
5. If installed, remove PEM.
6. Remove the side wall
Steps
1. Disconnect the control panel cable from the connector on the system board.
2. Using the Phillips #1 screwdriver, remove the screws that secure the left control panel and the cable cover to the system.
a. Remove the cable cover away from the system.
3. Holding the cable, slide the left control panel out of the system.
NOTE: Observe the routing of the cable as you remove the left control panel from the system.
assembly.
shroud.
After working inside your
Safety
Before working inside your
shroud.
assembly.
bracket.
system.
instructions.
system.
Installing and removing system components 195