Dell PowerEdge R860 Installation And Service Manual page 15

Table 6. Rear view of the system (continued)
Item Ports, panels, or slots
12 OCP NIC card (optional)
13 NIC ports (optional)
14 Power supply unit (PSU1)
NOTE: For more information about the ports, see the
Icon Description
either the front or rear button is pressed again. Press the button to
toggle between on or off mode.
NOTE:
hold the System ID button for more than five seconds to enter
the BIOS progress mode
NOTE:
page by pressing F2 during system boot), press and hold the
System ID button for more than 15 seconds.
N/A The OCP NIC card supports OCP 3.0. The NIC ports are integrated
on the OCP card which is connected to the system board.
The NIC ports that are integrated on the LOM card provide network
connectivity which is connected to the system board.
PSU1 is the primary PSU of the system.
Technical Specifications
If the server stops responding during POST, press and
To reset the iDRAC (if not disabled on the iDRAC setup
section.
Dell PowerEdge R860 system overview 15