Table of Contents
Advertisement
Icon
Name
1–16
Alarm input port 1–16
Ground
NO1–NO5
C1–C5
Alarm output port 1–5
NC5
A
RS-485 communication port
B
CTRL (CTRL 12 V)
—
P (+12 V)
—
RS-232
RS-232 debug COM
VGA
VGA video output port
Function
● There are four groups. The first group is from
port 1 to port 4, the second group is from port 5
to port 8, the third group is from 9 to 12, and
the fourth group is from 13 to 16. They are to
receive the signal from the external alarm
source. There are two types; NO (normal
open)/NC (normal close).
● When your alarm input device is using
external power, please make sure the device
and the NVR have the same ground.
Alarm input ground end.
● 5 groups of alarm output ports. (Group 1:
port NO1–C1, Group 2:port NO2–C2, Group 3:
port NO3–C3, Group 4: port NO4–C4, Group 5:
port NO5, C5, NC5). Output alarm signal to the
alarm device. Please make sure there is power
to the external alarm device.
● NO: Normal open alarm output port.
● C: Alarm output public end.
● NC: Normal close alarm output port.
RS485_A port. It is the cable A. You can connect
to the control devices such as speed dome PTZ.
RS485_B. It is the cable B. You can connect to
the control devices such as speed dome PTZ.
Controller 12 V power output. It is to
control the on-off alarm relay
output. It can be used to control the
device alarm output. At the same
time, it can also be used as the
power input source of some devices
such as the alarm detector.
+12 V power output port. It can
provide the power to some
peripheral devices such as the
camera or the alarm device. Please
note the supplying power shall be
below 1 A.
It is for general COM debug to configure IP
address or transfer transparent COM data.
VGA video output port. Output analog video
signal. It can connect to the monitor to view
analog video.
72
User's Manual
The two
ports
serve as
another
group of
alarm
output
ports.
Advertisement
Table of Contents
