Dahua DHI-NVR5432-EI User Manual page 133

Parameter
Network Mode
Default Ethernet Port
IP Version
DHCP
MAC Address
IP Address
Subnet Mask
Default Gateway
To unbind NIC, on the TCP/IP page, click
Device restarts.
3. On the TCP/IP page, configure DNS server. This step should be performed when you
enable the domain name service.
You can get DNS server address or manually enter it.
Automatically get DNS server address: When there is a DHCP server in the network,
●
you can enable DHCP, and then the Device gets a dynamic IP address.
Table 5-3 Network parameters
Description
Single NIC: Two network adapters work separately. If one of the
●
two network adapters is disconnected, the system network status
is regarded as offline.
Fault Tolerance: Two network adapters share one IP address.
●
Normally only one network adapter is working. When this adapter
fails, the other network adapter will start working automatically to
ensure the network connection.
When you test the network status, the network is regarded as
offline only when both network adapters are disconnected.
The two network adapters are used under the same LAN.
Load Balance: Two network adapters share one IP address. The
●
two adapters work at the same time to share the network load
averagely. If one of them fails, the other can continue working
normally.
When testing the network status, the network is regarded as
offline only when both of the two network adapters are
disconnected.
The two network adapters are used under the same LAN.
The Device with single Ethernet port does not support this function.
Select IPv4 or IPv6. Both versions are supported for access.
Enable the system to automatically obtain a dynamic IP address.
Displays the MAC address of the Device.
Enter the IP address and then configure the corresponding subnet
●
mask and default gateway.
After configuration, click Test to check whether there is conflict in
●
IP address.
IP address and default gateway must be on the same network
segment.
119
. The unbinding will take effect after the
User's Manual