Specifications - Carrier TruVu UCXP683T Installation And Startup Manual

What is the TV-UCXP683T?
You can use the TV-UCXP683T's physical communication ports as follows:
Port Port type
Eth0 10/100 Mbps Ethernet*
Eth1
S1 High-speed EIA-485 port
I/O Bus Electrically isolated EIA-485 port
* The Ethernet ports can run Modbus simultaneously with either BACnet/IP or BACnet/Ethernet.
The TV-UCXP683T also has the following ports:
•
Rnet port for connecting ZS sensors, an Equipment Touch, an TruVu™ ET Display, and Wireless Adapter for
wireless sensors
•
Service USB port for connecting locally to controller setup pages, the TruVu™ ET Display, or the Carrier
wireless service adapter
•
Comm USB port for other communication options in the future
•
Act Net port supports a combination of up to 5 Act Net addresses, as follows:
Address 1 is reserved for the Carrier actuator
○
Address 2 and 3 are reserved for the VAV Zone II Secondary Duct
○
Address 4 and 5 for i-Vu® Smart Valves
○

Specifications

Driver
Maximum number of control programs*
Maximum number of BACnet objects*
Third-party BACnet integration points
NOTE Must be on the BACnet/IP network
Third-party Modbus integration points
* Depends on available memory.
TruVu™ UCXP683T
Installation and Start-up Guide
For this type of
communication...
BACnet/IP,
BACnet/Ethernet, and/or
Modbus TCP/IP
BACnet/MSTP
or
Modbus Serial
I/O expanders (future)
drv_fwex_< version >.driverx
10
12000
1050
50
2
At...
10 or 100 Mbps
9.6 to 115.2 kbps
9.6 to 115.2 kbps
CARRIER CORPORATION ©2022
All rights reserved