To set up the controller through the Service port
To set up the controller through the Service port
You can communicate with the TV-UCXP683T through a web browser by connecting a computer to the controller's
Service Port using either the Carrier wireless service adapter or a USB cable.
NOTE You cannot access the Service port by plugging an Ethernet cable into Eth0 or Eth1.
Once you are connected to the network, you can:
•
Access the controller setup pages
•
Address and configure controllers
•
View the controller's Module Status report
•
View/change controller and network settings. Changes take effect immediately.
•
Troubleshoot
•
Use BACnet/Service port to access the i-Vu® application or a touchscreen device. See To communicate
through a BACnet/Service port network (page 46).
To access the controller setup pages and use the Local Network tab, you must first connect to and manually
address one TV-UCXP683T. For instructions on connecting, see Addressing the TV-UCXP683T through the Service
port (page 9). Navigate to http://local.access or http://169.254.1.1 to access the pages. Then set up the address
on your selected TV-UCXP683T on the Ports tab (page 47).
NOTE The first time you access the controller in the i-Vu® interface, after you have changed settings through the
Service port, be sure to upload the changes to the system database. This will preserve those settings when you
download memory or parameters to the controller.
ModStat tab
This tab provides the controller's Module Status report that gives information about the controller and network
communication status. See Appendix - Module Status field descriptions (page 65).
TruVu™ UCXP683T
Installation and Start-up Guide
46
CARRIER CORPORATION ©2022
All rights reserved