General workflow for using media
Introduction
Use the following workflow to handle the media correctly.
Step
Action
Configure media in the RIP on page
1
manage the profiles in the RIP.
Prepare media for printing on page
2
core on the roll winder and calibrate your media.
Print with or without winding on page
3
take-up roll core to wind media, with or without a tension bar.
Cut and unload media on page
4
the media drawer.
40. Download and install a media profile, and
82. Load a media roll in the media drawer, a
123. Print without winding or tape media to the
150. Cut media and unload a roll from the winder and
General workflow for using media
Chapter 4 - Handle the media
39