Canon Colorado 1650 Operation Manual page 107

11. Use both hands to turn the weak media roll and slide the media under the metal paper guide until
the media is transported automatically. You will hear a beeping sound when the media is
correctly fed and loaded.
IMPORTANT
Make sure media is always rolled up evenly on the core. Do not load media that is not
rolled up evenly (telescoping) as it can damage the machine.
12. Close the media drawer carefully. The operator panel displays the message that new media is
detected and an icon in the top left corner indicates that a roll is loaded for inside printing. This
can take 5 seconds.
IMPORTANT
Do not open the media drawer when the indicator light is off, you can damage the
machine.
13. On the operator panel, select the correct media type and fill in the media width.
14. When the media you use has an upward curl select [ Upward curled media].
This setting persists as long as the media is assigned. When enabled, the system feeds the media
to the output position. You can then open the top cover and guide the media. After you close the
top cover, the media is transported to the clamp. Open the top cover and guide the media again.
Printing starts after these actions have been completed.
15. Tap on [Save].
NOTE
For the highest output quality, it is advised to always perform a media calibration when
you load a new media type or a new media width. For more information, see
the media on page
After you finish
After the weak media is loaded, a print job does not start automatically. First you have to:
1. Feed the media. For more information see
2. Transport the media on the platen to the desired position. For more information see
media by distance on page
118.
Feed and retract media manually on page
Transport media by manual control on page
141,
Load weak media for outside printing
Calibrate
140.
Chapter 4 - Handle the media
138.
Transport
107