Autocut - Canon Colorado 1650 Operation Manual

AutoCut

AutoCut
Introduction
When you want to print a job in sheets, you can choose to cut the media automatically after each
copy. For AutoCut, the printer uses the embedded knife.
NOTE
Media categories that need a tension bar or request a manual cut cannot be cut automatically
after each copy.
Before you begin
• Printing with a cut after each copy is set in the [Output configuration] on the operator panel.
• It is highly recommended to change the [Output configuration] only when the queue is empty.
Procedure
1. Check the media category of your media and make sure the media type configuration is set
correctly in the RIP:
1. Set [Winding tension] to [no tension bar].
2. Check the box in front of [Suitable for printer cutter].
3. Check the box in front of [Printer does copies].
2. When you want to add white space between each copy, you have to define a leading or trailing
strip in the RIP:
1. Open the layout preview of your job in the RIP.
2. Fill in the leading or trailing strip and make sure the value of the [Intercopy spacing] is the
sum of their lengths.
If you had defined a leading or trailing strip by default on the operator panel, reset the values
to 0.
3. On the operator panel tap on the [Output] icon.
4. Tap on [Output configuration].
154 Chapter 4 - Handle the media