Canon Colorado 1650 Operation Manual page 345

2. Check if the media quality is ok. If not, try a different media.
Check if the [Media thickness] setting in the RIP is correct.
3. Perform a media calibration.
the darker or lighter lines in 1st meter (40") of the print caused by the media step.
4. Make sure that the [Automatic advance correction] setting in the RIP is enabled. Use enhanced
Change the media settings on page
markers.
5. When you are printing in [High quality] print mode, several print modes offer multiple print
strategies, that may reduce specific artefacts. Change the [Print strategy] setting.
media settings on page
6. Check the vacuum settings, see
7. Perform manual or periodic maintenance with [Advanced automatic nozzle optimization].
8. Select a higher quality print mode.
After you finish
When the problem is not solved, contact your application specialist or local Service
representative.
Calibrate the media on page
65.
Change the media settings on page
Select a print mode on page
118. A media calibration will minimize
65.
75.
Chapter 9 - Troubleshooting and support
Lines at swath boundary
Change the
65.
345