Canon Colorado 1650 Operation Manual page 125

NOTE
Make sure you set the output configuration in time, as you cannot change the
configuration once the media has passed the clamp.
4. Optional: set [ Wind the printed side] to [ Outside] or [Inside].
The default value is [ Outside]. When the setting is not available, the output will be winded with
the printed side to the outside.
5. Start a print job.
The printer will continue printing. The clamp closes when the media reaches the tape position,
and the operator panel gives a message indicating you can tape the media.
6. Make sure the media guides are out of the way as they can damage the media.
7. Take the leading edge of the media and align it on the core.
8. Tape first the center and then the sides of the media to the core, as shown on the operator panel.
For outside winding feed the media along the front of the core, for inside winding feed the media
along the back of the core.
for outside winding:
for inside winding:
Print and wind without a tension bar
Chapter 4 - Handle the media 125