Configure, Download, And Install Software Updates From On Remote Service - Canon Colorado 1650 Operation Manual

Configure, download, and install software updates from On
Remote Service
Introduction
When you configured the download and installation of operating system updates from On
Remote Service, the print server behaves as follows:
• Once a day the printer searches for new operating system or PRISMAsync updates at midnight.
When the operating system updates are discovered by the printer, it is not possible to make a
selection of the found updates. All found updates are downloaded or installed depending on the
configuration. During the download or installation, the printer remains operational. To finalize the
installation, you must restart the system.
Before you begin
Ensure that [Remote connection] is enabled on the printer:
1. On the operator panel, tap on the [System] icon on the right.
2. Tap on [Remote services]→[Remote connection]
3. Make sure:
• [Remote connection] is enabled.
• [Remote connection status] is connected.
Configure the download and installation of software updates from ORS
1. Open the Settings Editor and go to: [Support]→[Software updates].
NOTE
If the system is offline or shut down at midnight, the updates will be checked for
again the next day.
NOTE
You must be logged in as a system administrator. See
administrator on page
NOTE
A proxy may be required to access the internet and make use of Remote
services. When required, make sure the proxy settings are configured correctly.
For more information, see

Configure, download, and install software updates from On Remote Service

277.
Configure the network on page
Log in as a System
274.
Chapter 9 - Troubleshooting and support 313