Vacuum The Chiller And Check The Fluid Level (First Design) - Canon Colorado 1650 Operation Manual

Vacuum the chiller and check the fluid level (first design)

Introduction
It is advised to vacuum the chiller every month to keep the printer in the best condition.
Vacuuming the chiller is part of periodic maintenance so the operator panel gives a warning
when you should vacuum the chiller. Always check the fluid level when you vacuum the chiller.
Vacuum the chiller
Video:
NOTE
There are 2 types of chillers. In the first design, the condenser surface is located on the left side
of the chiller. In the new design, the condenser surface is located directly behind the cover. This
procedure describes the first design.
First design
Before you begin
Use Colorado 1650 prescribed:
• Screwdriver (Torx-25)
• Vacuum cleaner with a brush head
Check the fluid level
1. To check the fluid level, on the operator panel tap on the [Tools] icon on the right.
2. Go to [Chiller].
The operator panel displays the fluid level.
Vacuum the chiller and check the fluid level (first design)
.
New design
Chapter 6 - Maintain the system 237