Calibrate The Media - Canon Colorado 1650 Operation Manual

Calibrate the media

Calibrate the media
Introduction
In case of print quality issues you should always perform a media calibration.
It is advised to calibrate media when you have loaded a new media type or media width.
NOTE
Media calibration is type and width dependent. When you have two different sizes of the same
media type you must perform calibration for each size.
Procedure
1. On the operator panel tap on the [Media] icon on the right.
2. Tap on the arrow to select the roll you want to calibrate and tap on [Calibrate].
The printer starts the calibration. Two small prints are made that can be disposed. This process
can take several minutes.
3. When the calibration is finished a message will appear on the operator panel, tap on [OK].
118 Chapter 4 - Handle the media