Set Up And Operation; Control Modes; One Vintage (Static Color); Multiple Vintages (Dmx Control) - SHOWTEC Vintage Blaze 33 Value Line V2 Manual

Vintage Blaze '33 Value Line

Set Up and Operation

Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.

Control Modes

There are 2 modes:

One Vintage (Static Color)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Plug the end of the electric mains power cord into a proper electric power supply socket.
04) When the Vintage is not connected with a DMX cable, it functions as a stand-alone device. Please
see pages 16 – 18 for more information about Static Color.

Multiple Vintages (DMX Control)

01) Fasten the effect light to a firm trussing. Leave at least 0,5 meter on all sides for air circulation.
02) Always use a safety cable (ordercode 70140 / 70141).
03) Use a 3-pin XLR cable to connect the Vintages and other devices.
04) Link the units as shown in Fig. 13. Connect the first unit's DMX "out" socket with the second unit's "in"
socket, using a DMX-signal cable. Repeat this process to link the second, third and fourth units.
05) Supply electric power: Plug electric mains power cords into each unit's Powercon socket, then plug
the other end of the mains power cord into proper electric power supply sockets, starting with the
first unit. Do not supply power before the whole system is set up and connected properly.
Ordercode: 43324
● Static Color (manual)
● DMX-512 (1CH, 2CH, 4CH or 11CH)
12