Backside; Installation; Set Up And Operation - SHOWTEC LED Octostrip Set MKII 100 cm Manual

LED Octostrip Set MKII 100 cm

Backside

Fig. 03
12) 5-pin XLR LED Octostrip MKII 1-8 OUT
13) Mounting bracket + quick locks

Installation

Remove all packing materials from the LED Octostrip Set MKII 100 cm. Check if all foam and plastic
padding is removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Connect the device to the main power supply.
Ordercode: 42232
9