Table of Contents
Advertisement
Set Up and Operation
Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Damages caused by non-observance are not subject to warranty.
Control Modes
FUNCTIONS:
There are 5 modes for using the LED Par 64:
One LED Par 64
(Manual
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
When the LED Par 64 is not connected by a DMX-cable, it functions as a stand-alone device.
If device is set to
manually controlled.
One LED Par 64
(Built-in Programs, Auto
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2.
When the LED Par 64 is not connected by a DMX-cable, it functions as a stand-alone device.
If device is set to
built-in programs.
One LED Par 64 (Sound-control)
1.Plug the end of the electric mains power cord into a proper electric power supply socket.
2.
Turn on the music. If device is set to
react to the beat of the music.
Multiple LED Pars
1. Fasten the effect light onto firm trussing. Leave at least 0,5 meter on all sides for air circulation.
2. Use a 3-p XLR cable to connect the LED Par 64.
The pins:
3. Link the units as shown in (Fig. 4), Connect a DMX signal cable from the first unit's DMX "out"
socket to the second unit's "in" socket. Repeat this process to link the second, third, and fourth units.
You can use the same functions on the master device as described on page 12 (Built-in Programs or
Music control). This means on the master device you can set your desired operation Mode and all
slave devices will react the same as the master device.
Control)
,
,
Please see page 12 for more information about manual control Mode.
or
Please see page 12 for more information about the built-in programs.
(Master/Slave control)
1.
Earth
2.
Signal -
3.
Signal +
Multiple LED Pars
• Manual control
• Built-in Programs
• Sound-controlled
• Master/Slave
• DMX512 (1, 2, 3 or 7 Channels)
or
and you have pressed enter, then the fixture is
Run)
and you have pressed enter, then the fixture will play one of its
(Audio) and you have pressed enter, then the fixture will
(Master/Slave control)
7
Fig. 4
Advertisement
Table of Contents
