Backside; Installation; Set Up And Operation - SHOWTEC Stage Blinder 2 Blaze Manual

Stage Blinder 2 Blaze

Backside

Fig. 02
05) Pro power True 1 power connector OUT IP65
06) Pro power True 1 power connector IN IP65
07) OLED display + control buttons
08) 3-pin DMX signal connector IN IP65
09) 3-pin DMX signal connector OUT IP65

Installation

Remove all packing materials from the Stage Blinder 2 Blaze. Check that all foam and plastic padding is
removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.

Set Up and Operation

Follow the directions below, as they pertain to your preferred operation mode.
Before plugging the unit in, always make sure that the power supply matches the product specification
voltage. Do not attempt to operate a 120V specification product on 230V power, or vice versa.
Ordercode: 30782
8