Backside; Installation; Installing The Lamp - SHOWTEC Vintage Blaze 33 Value Line V2 Manual

Vintage Blaze '33 Value Line

Backside

Fig. 02
07) Ground/Earth connection
08) Blue Powercon connector 100-240V IN
09) White Powercon connector 100-240V OUT
10) Automatic circuit breaker
11) LCD display + menu buttons
12) RJ-45 connector for updating software.
Note: updating software is only allowed by a Highlite technician
13) 3-pin DMX signal connector OUT
14) 3-pin DMX signal connector IN
15) 5-pin DMX signal connector OUT
16) 5-pin DMX signal connector IN

Installation

Remove all packing materials from the Vintage Blaze '33 Value Line. Check if all foam and plastic
padding is removed. Connect all cables.
Do not supply power before the whole system is set up and connected properly.
Always disconnect from electric mains power supply before cleaning or servicing.
Damages caused by non-observance are not subject to warranty.

Installing the Lamp

The Showtec Vintage Blaze '33 Value Line uses the GY9.5 lamp (ordercode 80703O or 80703G) as
manufactured by all popular manufacturers. Use only the appropriate lamp for your unit.
Note that, product versions that use other lamps, may be offered in the future. Check your product
specification label for information.
Always disconnect from electric mains power supply before changing lamps.
The lamp has to be replaced when it is damaged or deformed due to the heat.
Do not install lamps with a higher wattage! Lamps with a higher wattage generate temperatures the
device was not designed for.
Damages caused by non-observance are not subject to warranty.
Ordercode: 43324
8