Table of Contents
Advertisement
Chapter 10: Building Stacks with Multi-Gigabit Copper Ports
Configuring
Member Switches
- Part I
Step
1
Power on a member switch and wait one minute for it to start the AlliedWare Plus
management software. Refer to "Powering On the Switch" on page 110.
2
Start a local management session. Refer to "Starting a Local Management Session"
on page 112.
3
Enter the ENABLE and CONFIGURE TERMINAL commands to move to the Global
Configuration mode:
awplus> enable
awplus# configure terminal
Enter configuration commands, one per line. End with CNTL/Z.
awplus(config)#
Step 4 sets the member switch's ID number.
4
Set the ID number of the member switch with the STACK RENUMBER command.
Each switch must have a unique ID number. The default value is 1. If you are using
the worksheet on "VCStack Worksheet" on page 60, refer there for the ID numbers.
This example changes the switch's ID number from the default value 1 to the new
ID 2.
awplus(config)# stack 1 renumber 2
% Warning: the new ID will not become effective until the stack-
member reboots.
% Warning: the boot configuration may now be invalid.
The remaining steps reboot the unit. (You do not have to update the configuration file with the
WRITE command after changing a switch's ID number.)
5
Enter the EXIT command to return to the Privileged Exec mode.
awplus(config)# exit
142
5. Restart the switch with the REBOOT command.
6. Start a new local management session.
7. Verify your changes with the SHOW STACK and SHOW RUNNING-
CONFIG INTERFACE commands.
Perform the procedure in Table 14 to perform Part I to configure a member
switch.
Table 14. Configuring Member Switches - Part I
Description and Command
Advertisement
Table of Contents
