Table of Contents
Advertisement
Concluding steps
▶ Install riser module 3/4, see
page
62.
▶
"Reassembling" on page
▶
"Connecting the power cord (AC PSU)" on page
▶
"Switching on the server" on page
▶ Configure the new MAC address in the OS, if you have no VIOM
(ServerView Virtual-IO Manager) installed.
If you have VIOM installed, it is not necessary to configure the MAC
address.
This is virtualized by VIOM.
▶ Inform the customer about new MAC addresses. For more information, see
"Basic information" on page
▶
"Updating the NIC configuration file in a Linux and VMware environment" on
page
107.
▶
"Configuring LAN teaming" on page
9.5.3
Removing an OCP module
Upgrade and Repair Unit
(URU)
– Forceps
Tools:
– Phillips PH2 / (+) No. 2 screw driver (for housing cover)
Preliminary steps
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶ Remove riser module 3/4, see
page
61.
RX4770 M5
Expansion cards and backup units
"Installing the riser module 3/4 and 6/7" on
53.
59.
110.
116.
45.
"Removing the riser module 3/4 and 6/7" on
Upgrade and Maintenance Manual
58.
Hardware: 5 minutes
46.
47.
185
Advertisement
Table of Contents
