Table of Contents
Advertisement
Tools:
Phillips PH2 / (+) No. 2 screw driver
Note on network settings recovery
When replacing network controllers, network configuration settings in
the OS will be lost and replaced by default values. This applies to all
static IP address and LAN teaming configurations.
Ensure to note down your current network settings before replacing a
controller.
Preliminary steps
▶ If applicable,
"Note on network settings recovery" on page
▶
"Locating the defective server" on page 43
▶
"Suspending BitLocker functionality" on page
▶ If
applicable,"Disabling the boot watchdog" on page
▶
"Shutting down the server" on page
▶
"Disconnecting the power cord" on page
▶
"Getting access to the component" on page
▶
"Locating the defective component" on page
▶ For slot 3, 4, 5, 6 and 7: Remove the corresponding riser module, see
"Handling riser modules" on page
Removing the defective expansion card
▶ Remove the expansion card, see
page
209.
▶ If the slot bracket on the defective expansion card is to be reused, remove it
from the expansion card, see
RX4770 M5
Expansion cards and backup units
45.
60.
"Removing the expansion card" on
"Removing a slot bracket" on page
Upgrade and Maintenance Manual
85.
86.
46.
47.
44.
211.
173.
211
Advertisement
Table of Contents
