Display Of Values With More Than Two Digits; Flow Diagram Control System - REMEHA Quinta 45 Technical Information

6.1.4 Display of values with more than two digits

The display has only two digits available therefore values over this are displayed as
follows :
- negative values will be indicated by a dot behind the last digit e.g. 1) = -10
- values from 00 to 99 will be indicated without any punctuation marks
- values from 100 to 199 will be indicated by a dot between both digits
e.g. )0 = 100, !0 = 110, (9 = 199.
- values from 200 to 299 will be indicated by a dot behind every digit
e.g. )) = for 200, !) = 210, (( = 299.

6.2 Flow diagram control system

press the 'm' -key
Operating mode,
see Par. 6.3
Setting mode,
see Par. 6.5 and
Par. 6.6
55979.indd 18 55979.indd 18
'code'-display
only digit or letter
0 - 9,h,l,b Flow temperature or shut-off code
digit or letter with
dot
Flow temperature set point
!
Pump run on time HTG
@
DHW temperature set point
#
Boiler control setting
A
n/a
u
service engineer level only:
Flow temperature set point during forced part
$
load
High limit temperature set point
%
Fan speed at full load (HTG)
^
Fan speed at part load (HTG and DHW)
&
Modulation start point Τ (F/R)
*
18
Quinta 45/65
press the 's'-key
tdisplay
Remeha
2-4-2009 9:42:37 2-4-2009 9:42:37