Setting Mode; User Level Setting Mode (X; Flow Temperature (!) - REMEHA Gas 310 ECO Technical Information

13

SETTING MODE

13.1 User level setting mode (X [[)

Setting mode is used to change various settings to suit individual requirements. The required code is selected by
pressing the m key until ! appears in the code window. Select the required code with the s key. Now press the [+]
key to increase a setting or the [-] key to decrease a setting.
Press the e key to store the new setting. The new value will flash twice in the t window to confirm the setting.
Code Description
Flow temperature setpoint, see section
!
13.1.1
@
Pump run on setting, see section 13.1.2
A
Boiler control setting, see section 13.1.3
table 16 Settings mode user level
g
Changing @ and A should only be on design engineers advice.
Important!!

13.1.1 Flow temperature (!)

The required flow temperature is adjustable from 20 to 90°.
The following diagram shows a typical example of this procedure:
fig. 25 Setting flow temperature
pdf
Supplied By www.heating spares.co Tel. 0161 620 6677
Remeha Gas 310 ECO
Setting range and explanation if necessary
20 to 90°
(boiler thermostat setting, also top heating
curve setting if external sensor is used)
00
= pump run on 10 seconds
01 - 15 = pump run on in minutes
99
= continuous pump operation
Control mode (modulating-on/off-etc.)
40
Factory
setting
90
05
51