Xerox AltaLink C81 Series User Manual page 298

Troubleshooting
Probable Causes
Application and print driver have conflicting tray
selections.
An Imaging Security mark has been detected.
D D o o c c u u m m e e n n t t P P r r i i n n t t s s f f r r o o m m W W r r o o n n g g T T r r a a y y
Probable Causes
Application and print driver have conflicting tray
selections.
P P r r i i n n t t e e r r i i s s M M a a k k i i n n g g U U n n u u s s u u a a l l N N o o i i s s e e s s
Probable Causes
One of the trays is not installed correctly.
There is an obstruction or debris inside the printer.
The printer beeps at each touch on the control panel.
298 Xerox AltaLink
® ®
User Guide
C81XX Series Color Multifunction Printer
Solutions
For details, see Document Prints from Wrong
The Imaging Security feature is enabled, and a
security document has been detected and deleted.
For information about the Imaging Security feature
settings, contact your system administrator or refer
to the System Administrator Guide at
com/office/ALC81XXdocs.
Solutions
1 Check the tray selected in the print driver.
2 Access the page setup or printer settings of the
application from which you are printing.
3 Set the paper source to match the tray selected in
the print driver or set the paper source to
Automatically Select.
4 Check that you have the latest print driver
installed. For details, go to
ALC81XXsupport.
Note: To have the print driver select the tray,
set the tray used as the paper source to Auto
Selection Enabled.
Solutions
Open and close the tray from which you are printing.
Power off the printer and remove the obstruction or
debris. If you cannot remove the obstruction, contact
your Xerox service representative.
®
Check the Alerts setting. For details, refer to the
System Administrator Guide at
office/ALC81XXdocs.
Tray.
www.xerox.
www.xerox.com/office/
www.xerox.com/