Canon ImagePROGRAF iPF650 Series Service Manual page 266

Chapter 8
Display massage
Hardware error. 03130031-2F27
03130031-2E27
Turn off printer, wait,
then turn on again.
Hardware error. 03130031-2F1F
03130031-2E1F
Turn off printer, wait,
then turn on again.
Hardware error. 03130031-2F2A
03130031-2E2A
Turn off printer, wait,
then turn on again.
Hardware error. 03010000-2F29
03130031-2E29
Turn off printer, wait,
then turn on again.
Hardware error. 03130031-2F2E
03130031-2E2E
Turn off printer, wait,
then turn on again.
Hardware error. 03130031-4027
03130031-4027
Turn off printer, wait,
then turn on again.
Hardware error. 03130031-2F13
03130031-2E13
Turn off printer, wait,
then turn on again.
Hardware error. 03130031-2F32
03130031-2F32
Turn off printer, wait,
then turn on again.
Hardware error. 03130031-2F3A
03130031-2F3A
Turn off printer, wait,
then turn on again.
Hardware error. 03130031-2F3B
03130031-2F3B
Turn off printer, wait,
then turn on again.
Hardware error. 03130031-260E
03130031-260E
Turn off printer, wait,
then turn on again.
Hardware error. 03130031-2618
03130031-2618
Turn off printer, wait,
then turn on again.
Hardware error. 03130031-260F
03130031-260F
Turn off printer, wait,
then turn on again.
Roll feed unit err 03060B00-2E24
Turn off printer and
check roll feed unit
Unknown file. 03900001-4049
Check file format.
Turn off printer, wait a
while, then turn it on
again.
Unknown file. 03900001-4042
Check file format.
Turn off printer, wait a
while, then turn it on
again.
8-6
Code* Condition detected
Carriage travel timeout
Pump cam sensor error
Unable to detect the feed roller home position
Feed motor timeout (Roll media)
Roll travel timeout
Lift travel timeout error
A/D converter external trigger output stop detection
hardware error 1
Multi sensor error
Valve motor error
CS communication error
Gap detection error
VH voltage error
Gap reference surface error
Roll feed unit failure
ROM data for another model has been transferred.
MIT data transfer failure
Action
Check the carriage unit and surrounding parts.
Check the purge unit.
Check the feed roller encoder and surrounding part.
Check to see if paper has not jammed.
Check the roll feed unit. Check roll media. Check to see
if paper has not jammed in the printer.
Check the roll feed unit.
Check the carriage unit and surrounding parts.
Replace the new printhead.
Check the environment for interferences from outside
light.
Replace the multi sensor unit.
Check the ink supply unit.
Remove the ink tanks and then reload them.
Check the main controller PCB.
Check the carriage unit and surrounding parts.
Replace the main controller PCB.
Check the power supply unit.
Replace the reference surface sheet.
Replace the roll feed unit.
Transmit valid ROM data.
Verify the validity of MID data before transferring it.