Table of Contents
Advertisement
CARE & MAINTENANCE
COVER (STYLE MAY VARY)
The restraint has a flame retardant cover which is removable for cleaning.
Cleaning instructions are on the care label attached to the cover. If fluffy
cover is fitted then washing cover prior to use will remove excess fluff.
Drying the insert pad will take additional time as the impact foam will absorb
moisture. Before washing re-engage the hook and loop on the cover and inset
pad to prevent the 'hook' damaging the fabric.
The cover has been designed to protect your child when seated in the
restraint. Care should be taken if children either eat or drink while in the
restraint as some food or drink products may cause damage or marking to the
cover. Wash or clean immediately.
Do not pull sticky items from covers as the cover may be damaged - soak in
water and gently remove.
IMPORTANT:
Do not pull sticky items from covers as the cover may be damaged - soak in water and gently remove.
TO REMOVE COVER
You do not have to remove the shoulder harness assembly from the restraint. However, you do need to
disconnect the shoulder harness straps from the metal strap connector at the back of the restraint. Then
follow the sequence below A to G to remove the cover.
A. Disengage Harness Tongues from Harness Crotch Buckle.
B. Disengage both straps from metal strap connector. Pull the shoulder straps out of the shoulder strap
slots. Remove any Head Roll or Padded Insert.
C. Unhook Elastic Loops at the top rear of the seat.
D. Release fabric cover overhang at the side of the seat.
E. Undo Plastic Clips at the front of the seat.
F. Feed Crotch Buckle through slot in cover.
G. Carefully remove trim cover away from restraint whilst feeding through the crotch buckle, harness
adjuster (button type), harness tongues and straps through the lap and crotch strap slots in the cover.
56
Advertisement
Table of Contents
