To Remove The Cover; To Replace The Cover - Britax Steelcraft Instructions For Use Manual

CARE AND MAINTENANCE
COVER
For baby's comfort and health the Infant Carrier cover is removable
for cleaning. Cleaning instructions are on the care label attached to
the liner. Washing the cover prior to use will remove excess fluff and
dye's.

TO REMOVE THE COVER

A. Remove the Canopy and Baby insert
pad (if supplied) as described on page
15. Unclip the two infant carrier cover
straps which are secured by plastic
hooks under the handle attachment
point.
B. Disconnect the shoulder harness
straps from the Metal Strap Connector
and feed through shoulder slots in
both infant carrier and cover. Refer to
page 18.
C. Feed the shoulder harness straps and
tongues through lap strap slots in the
Cover only. There is no need to remove
the harness straps from the Infant
Carrier.
D. Lift the cover around the rim of the
infant carrier at the harness adjuster
end, feed the crotch buckle through
the slot in cover and pull the harness
adjuster strap out of the slots.
E. Remove the cover for cleaning.
34
Unhook clips on either
side of cover under the
handle then remove cover
Pull cover off
from the corners
CARE AND MAINTENANCE

TO REPLACE THE COVER

A. Place the cover over the infant carrier
ensuring all slots in cover line up with
slots in infant carrier.
B. Ensure that there are no twists in all
straps underneath the Infant Carrier.
C. Feed the shoulder harness straps
through lap strap slots in cover.
D. Feed the shoulder harness straps
through the shoulder strap slots in
cover and then in through the Infant
Carrier (ensure it is over the cross
bar). Refer to page 17 for correct
shoulder harness position for your
baby. Attach the shoulder harness
straps to the strap connector.
E. Feed the crotch buckle as well as the
harness adjuster strap through the
slots in the cover.
F. Refit plastic hooks on cover to Infant
Carrier as shown right.
G. Engage shoulder harness tongues and
crotch buckle. Pull to check harness
is attached.
H. Ensure the straps are not twisted.
Pull elastic cover
over Infant Carrier
Cross bar
Strap Connector
Plastic Hooks
35