Table of Contents
Advertisement
HOW TO SET-UP
TODDLER USE FORWARD FACING
INSTALLING INTO VEHICLE FORWARD FACING
A. Position the restraint in the car facing forward in the
chosen seating position. There must be a child restraint
anchorage fitting directly behind this seating position.
Refer to the vehicle owners manual for the location. If
not, refer to pages 62 to 65.
B. Some vehicle seat fabrics (particularly velours) may
be damaged by a child restraint used continuously. We
recommend the use of a seat protector or thick towel
to keep the vehicle seat in good condition.
C. Fully lengthen seatbelt. Insert seatbelt tongue through
the forward facing seatbelt path (yellow path),
ensuring that the seatbelt is behind the harness straps
and that the lap part of the seatbelt is below the hooks
as shown on page 44.
D. Engage seatbelt buckle & tongue. Push down on the
seat, whilst pulling the sash belt firmly. This should
make the lap belt tight across the restraint. Whilst
holding the seatbelt tension, ensure to remove all slack
from the lap part of the seatbelt 1 by pulling sash belt
2.
E. The child restraint should now be firmly fitted to the
vehicle seat. Allow the excess sash belt to feed back
into retractor ensuring no slack has been created by
the belt path.
NOTE: Seatbelt extenders should not be used if the
seatbelt is long enough to secure the child restraint. If
they are used then the buckle tongue must not enter the
seating zone.
42
Push down
2
Lap seatbelt
1
Pull sash
portion of
seatbelt to
remove slack
D
Advertisement
Table of Contents
