Table of Contents
Advertisement
HOW TO SETUP
BABY USE REARWARD FACING
STEPS IN CHANGING SHOULDER STRAP SLOTS
A. Remove the restraint from vehicle, if not already removed.
B. It is better to change one strap at a time, so that the
other strap will be a guide for reassembly.
C. At the rear of the restraint, remove one of the harness
shoulder straps from Metal Strap Connector by slipping
strap through open slot.
D. Pull the shoulder strap through slot.
E. Insert shoulder strap through restraint slot which will
position the shoulder strap level with or above the child's
then over the metal cross
shoulder,
that the shoulder strap passes through matching slots in
cover and restraint body. If using an accessory with slots,
ensure the straps are threaded through these before
inserting the strap in the slots in the backrest.
F. Reconnect the strap to the metal strap connector.
G. Repeat for the other side.
IMPORTANT:
Ensure the shoulder strap is threaded through the slot, then over the
top of the bar at the rear of restraint and connected to the metal strap
connector.
Do not use the restraint with harness shoulder straps set at different
heights
or fed through mismatching slots. Ensure harness straps are not twisted
and that all straps are secure by pulling each harness strap.
Remove the accessories while adjusting harness. The accessories are not be
used once child reaches the Lower Shoulder Height Marker or if it creates
discomfort.
30
Metal Cross
Bar
Metal
Strap
Connector
bar. Ensure
Pull
straps
D
E
Advertisement
Table of Contents
