Table of Contents
Advertisement
INSTALLATION OF CAR
ANCHOR FITTING
IF THE CAR IS FITTED WITH CHILD RESTRAINT
ANCHORAGE POINT
Locate the anchorage point behind the rear seating position.
(consult the car owners handbook for the location of the
anchorage point). The anchorage point should be directly behind
and central to the restraint. Remove thread plug from the parcel
shelf/floor/roof, etc. and install attachment bolt and fitting as
shown in Fig 1.
CAUTION: DO NOT OVERTIGHTEN ANCHOR BOLT.
OVERTIGHTENING MAY FRACTURE OR BREAK BOLT. MAXIMUM
TORQUE IS 20 Nm (14.75 ft.lb.)
Note: Minimum of five full turns of attachment bolt is required
before tightening force is applied.
IF THE CAR IS NOT FITTED WITH CHILD
RESTRAINT ANCHORAGE POINTS
For Sedans only - Drill 9mm diameter hole in the parcel
shelf on the centre line of the seating position as shown in Fig
3. Before drilling the hole, check the underside for accessibility.
Install the attachment bolt as shown in Fig 2.
For vehicles other than Sedans - In Australia, consult
your nearest child restraint fitting station or traffic authority
for vehicle inspection to find the best, correct position for
the placement of the anchorage point, and for the correct
attachment bolt length and use of spacers. In New Zealand,
consult the agent for the vehicle.
Note to Queensland purchasers: The installation of anchorage
points must be approved by authorised officers appointed by
Queensland Transport. Authorised officers can be sourced from
all Queensland Transport Customer Service and Queensland
Ambulance Service Centres.
64
UPPER ANCHORAGE FITTING
Fig.1.
Attachment Bolt
Lock washer
Anchor fitting
Spacer(s) if
required
Vehicle trim
Vehicle metal
structure
Front of Vehicle
UPPER ANCHORAGE
FITTINGS FOR SEDANS ONL Y
Fig.2.
Attachment Bolt
Anchor fitting
Spacer(s) if
required
Vehicle trim
Vehicle metal
structure
Reinforcing washer
(cone downwards)
Lock washer
Secure nut
Advertisement
Table of Contents
