Table of Contents
Advertisement
PREPARING FOR INSTALLING INTO VEHICLE - FORWARD FACING
The restraint is normally packaged in the fully upright forward
facing mode. If you need to use it rearward facing you must first
fully recline the restraint, and convert to rearward facing mode
as shown below.
If upper anchorage strap is folded up for storage undo storage
strap then lengthen. Fully press adjuster button (A) while pulling
upper anchorage strap (B) to lengthen.
INSTALLING INTO VEHICLE - FORWARD FACING
If changing from rearward facing to forward facing:
A. Remove the seat from the vehicle by disengaging the
seatbelt as described on pages 49 and 50.
B. Remove any insert pads (if fitted) as they are no longer
required.
C. Rotate the stabilising bar to the required forward facing
position shown on page 55.
IMPORTANT:
DO NOT USE RESTRAINT IN FORWARD-FACING POSITION WITH THE
STABILISING BAR DEPLOYED.
Do not recline into rearward facing position when using restraint in forward
facing mode.
Ensure harness are in the correct position (Refer to page 45).
HOW TO SET-UP
TODDLER USE FORWARD FACING
Fully press Adjuster Button (A) while
pulling Upper Anchorage Strap (B)
to lengthen.
A
B
41
Advertisement
Table of Contents
