Remove Cover - Britax Safe-N-Sound BS3700A-C20133 Series Instruction Manual

CARE AND MAINTENANCE - REMOVE COVER
3
1
2
62
Instructions for Installation & Use
TO REMOVE COVER FOR WASH:
NOTE: There is no need to disconnect the
shoulder harness assembly straps from restraint.
Step 1. Remove the restraint from vehicle.
Step 2. Disengage the harness tongues from
the harness buckle.
Step 3. Remove any accessories, infant insert,
crotch pad and shoulder pads (if
supplied).
To remove headrest cover:
Step 1. Lift headrest to the highest position and
unclip press studs on both sides, then
unhook clips on both sides attached
under headrest wings.
Step 2. Behind the headrest reveal the hidden
elastic, lift out and remove elastic over
and away from headrest.
Peel headrest cover away.
CARE AND MAINTENANCE - REMOVE COVER
To remove cover:
Step 1. Lift headrest to the highest position.
1
Step 2. Recline child seat to reveal elastic
2
Step 3. Unclip cover press studs from
3
Step 4. Open CLICKTIGHT frame and unhook
Unhook
clip inside
child seat
Step 5. Peel cover over headrest and harness
4
To remove CLICKTIGHT frame cover:
Step 1. Open CLICKTIGHT frame and unhook
Step 2. Feed over CLICKTIGHT button
1
Open door at the back of the child
seat and unhook elastic loops.
loops at the lower front of the child
seat and remove.
CLICKTIGHT base cover found inside
child seat.
clips inside the child seat as shown.
adjuster button, feed through harness
adjuster straps.
elastics from underneath.
housing.
63
Instructions for Installation & Use