Table of Contents
Advertisement
Machine Operation
1. LED Charger Indicator
To start charging the battery connect the main AC power supply to the AC socket (2)
located on the left rear of the machine.
The battery charger supplied with the MEWP was designed to ensure safe and
reliable performance. It is already fitted on the machine and does not need any
adjustment or configuration by the user; nonetheless, to avoid injury and damage
to the battery charger, the following essential precautions must be observed:
•
Carefully read installation instructions contained in this manual. For future reference,
keep manual in a safe place.
•
Do not place battery pack near heat sources.
•
Be certain type of power supply available corresponds to voltage specified and
indicated on the battery charger rating plate or in this Operation and Safety Manual.
If any questions, contact your local JLG Service Center or the local electrical
company.
•
An AC class circuit breaker can be used as a protection device for the battery charger
power supply, however it is recommended to use a class A or even better class B
device.
•
In regard to safety and electromagnetic compatibility, the battery charger features a
three pin plug with ground, which can only be plugged into an grounded socket. If
the plug does not go into the socket, the socket is likely old and not grounded. In
this case, contact an electrician to have the socket replaced. Do not use adapters to
resolve ungrounded circuit plug problems.
•
Ensure power cable is undamaged. If cable is worn or damaged, replace it
immediately.
•
If extensions or multiple sockets are used, make sure these support total rated
current.
76
1
2
2. AC Charge Socket
WARNING
31219187
BM001237A
EC450AJ, EC520AJ
Advertisement
Table of Contents
