DT4260 xx xx xx xx
Dismounting
20111006-V0
9. Dismounting
9.1. Dismounting procedure
Before dismounting take note the warnings written in
Chapter 5.1.
The following figure shows the dismounting procedures:
The dismounting procedure needs a screwdriver for slotted
screws. Before dismounting disconnect all wires.
1. Slip the tip of the screwdriver into the hole of the
mounting clamp (A) (Figure step 1).
2. Move the screwdriver handle to make free the clamp
(Figure step 2).
3. Keeping the screwdriver in this position draw back the
mounting clamp (Figure step 3).
Please do not exercise forces higher than necessary, as it
may cause damages to the clamp.
4. Repeat the 1., 2., 3. steps with the other clamp.
5. You can take out the instrument from the panel cutout.
9.2. Disposal
According with the concerning EU directive, the
Manufacturer undertakes the disposal of the instrument that
are manufactured by it and intended to be destroyed.
Please deliver it in contamination-free condition to the site of
the Manufacturer or to a specialised recycling company.
63