Checking The Rubber Grips - GAS GAS MC 250F 2022 Owner's Manual

11.41

Checking the rubber grips

Main work
–
Check the throttle cable routing.
Both throttle cables must be routed, side by side, on the back of
the handlebars and above the fuel tank bracket, to the throttle
valve body. Both throttle cables must be secured behind the rub-
ber strap of the fuel tank support.
» If the throttle cable is not routed as specified:
–
Correct the throttle cable routing.
A00824-10
Finishing work
–
Install the fuel tank.
–
Mount the seat. (
–
Check the rubber grips on the handlebar for damage, wear, and
looseness.
Info
The rubber grips are vulcanized onto a sleeve on the left and
onto the handle tube of the throttle grip on the right. The
left sleeve is clamped onto the handlebar.
The rubber grip can only be replaced with the sleeve or the
throttle tube.
401197-01
» If a rubber grip is damaged or worn:
–
Change the rubber grip.
–
Check that screw
Guideline
Screw, fixed grip
A
Diamond must be positioned visibly as shown in the figure.
A00822-10
SERVICE WORK ON THE CHASSIS 11
( p. 65)
p. 57)
1
is firmly seated.
M4 5 Nm (3.7 lbf ft)
Loctite ® 243™
73