Introduction; General; Welding Power Sources; Technical Data - ESAB PEI Instruction Manual

GB
2

INTRODUCTION

2.1

General

The welding control unit PEI is used together with A2 automatic welding equipment
for adjusting welding parameters and controlling the welding process.
It is intended for SAW or MIG/MAG welding with DC.
(N.B. PEI is set for SAW at delivery, if you want to change to MIG/MAG welding
contact ESAB)
2.2

Welding power sources

The welding power sources are specially adapted to work with the welding control
unit PEI.
2.3

Technical data

Supply voltage (tolerans ±10%):
Fuse:
No- -load power:
Permissible load:
at 100 % duty cycle
at 60 % duty cycle
Voltage setting reference signal:
Burn- -back time:
Pre- -flow / post flow time:
Power source output:
Gas/ auxiliary valve:
Voltmeter range:
Ammeter range:
External current shunts permissible:
Wire feed speed - - SAW :
Wire feed speed - - MIG/MAG:
Travel speed:
Embedded supply for external sensors:
Embedded supply for laser pointer lamp:
Temperature range:
Weight:
Dimensions:
Enclosure class:
Enclosure class
The IP code indicates the enclosure class, i. e. the degree of protection against penetration by solid
objects or water. Equipment marked IP 23 is designed for indoor and outdoor use.
fgc6d1ea
Welding control unit PEI
42 V, 50/60 Hz
16 A delayed
25 VA
40 V DC max
3.5 A
4.5 A (KSV5035/603)
0 -- 10,0 V
0 -- 2,0 s
0.5 s /1.0 s
30 V DC, 100 mA max -- NPN--OC
42 V 50/60 Hz -- 1A max
10 -- 99.9 V (3 digits)
30 -- 1999 A (3½ digits)
1000 A / 60 mV (factory setting)
1500 A / 60 mV
750 A / 100 mV
600 A / 60 mV
1.0 -- 9.0 m/min, 40 -- 355 IPM (KSV5035/375)
1.8 -- 16.2 m/min, 70 -- 640 IPM (KSV5035/374)
0.1 -- 2.0 m/min, 4.0 -- 80.0 IPM (KSV5035/603)
24V 300mA
3.3V/ 5V DC 50 mA
--10 -- 40_C (14 -- 104_F)
6.2 kg
197 x 227 x 220 mm
IP 23
- - 52 - -